2007 C175 New Holland Skid-steer, cranks but will not start.

[Soldierforlife]

Good afternoon all. I have an issue with my 2007 C175 New-Holland skid steer. A couple of weeks ago, I replaced the electronic fuel pump and everything was working fine. Now my skid-steer cranks, but will not start. I replaced both fuel filters two months ago as part of my regular hourly service. The fuel pump is working properly. I open the cockpit at the bottom of the fuel filter and is pumping fuel accordingly through both the in-line fuel filter and secondary fuel filter. I made sure that both fuel filters are full. Glow plugs are less than two months old. All fluid levels are correct. After I finish starting it, the hydraulic and oil lights are displayed, which were the reason why I replaced my electronic fuel pump. The Electronic fuel pump was not pumping fuel out previously, I made sure of that. Can someone please assist. Thank you all and God Bless you all.

 

[Bluehydrau]

I apologize for the late reply. Since the fuel system and glow plugs are functioning well, it's a good idea to check for any air in the fuel lines or look into injector issues. The hydraulic and oil lights point to potential problems with the engine control module or sensors, which might be causing the startup issues.

 

[olli3-blu]

To add, try checking the ground connections and the charge pressure switch. That switch is known to give false readings on C175s and can prevent starting even if everything else looks good

 

[Alan]

@Soldierforlife

Hey there, just checking in to see how things are going. Hope you were able to get this sorted out